Heating circuit distributor

Heating circuit manifold, fully assembled

Heating circuit manifolds are used as the interface between the heating system and the wall heating. The heating circuit manifolds have outlets to which the heating circuits are connected. To connect the heating circuits, the heating pipe is screwed onto the manifold with a Euro cone compression fitting. The return of the heating circuit is then connected to the corresponding return, and the cooled water is carried back to the heating system.

The hydraulic balancing is also set at the heating circuit manifold. On the flow, the resistance can be adjusted so that the resistances of all individual heating circuits are equal. This is also where the actuator is fitted; it opens and closes the flow according to the signal from the room thermostat.

Stainless steel, integrated valves, Topmeter 0-6 l with sight glass for balancing in the flow, fully automatic air vent, incl. 2 x fill and drain (KFE) valve and 2 x 1" female-thread ball valve on the circuit side