Stand oil paint, semi-fat

KREIDEZEIT Standölfarbe is a resin-free, biocide-free oil paint for wood indoors and especially outdoors. It remains elastic and does not flake or crack; instead, it weathers gradually at the surface and can be renovated by cleaning and overpainting. Only lightfast, weather-resistant earth and mineral pigments are used for pigmentation.

The coating system follows the “lean to rich” (fat over lean) principle: 1. primer oil, 2. stand oil paint -semi-rich- (Art. 442, silk matt to silk gloss, good filling effect), 3. stand oil paint -full-rich- (Art. 443, glossy finishing coat). For a lower sheen, two coats of -semi-rich- can be applied. Available in 14 intermixable standard shades, special shades on request.

Properties

• coloured, high opacity
• resin-free, biocide-free
• highly weather-resistant, elastic
• weathers at the surface – does not spall/crack/flake
• can be renovated by cleaning and overpainting
• no rust creep at damaged areas (on steel)
• resistant to saliva and perspiration according to DIN 53160
• cobalt-, lead- and barium-free
• contains solvent (gum turpentine oil)

Suitable substrates

Untreated or previously oiled wood, interior and exterior, including old oil and alkyd resin coatings (after testing, see the instructions “Testing existing coatings”). Not for use on acrylic/elastic synthetic resin coatings or roof surfaces; unsuitable for stoves/radiators; floors only on request.

Application & Processing

System build-up: 1. Primer oil (apply generously, allow to soak in, remove excess). 2. Stand oil paint -semi-rich- as primer/intermediate coat. 3. Stand oil paint -full-rich- as final coat – or two coats of -semi-rich- for a lower sheen.

Application: Apply thinly and evenly with a brush, allowing each coat to dry completely. Application temperature at least 8 °C; do not apply in direct sunlight.

Maintenance: Refresh weathered surfaces with KREIDEZEIT Care Oil.

Tools & cleaning: Paintbrush; clean immediately with gum turpentine, then wash with soap.

Technical data

Shades	14 mixable standard shades (+ gold/silver), custom shades on request
Structure	lean → fat: primer oil / semi-fat / full-fat
Use	Wood, interior & exterior; steel/zinc
Resin/biocides	contains no
Solvents	balsam turpentine oil (gum turpentine)
Tests	DIN 53160

Full declaration

Linseed oil, linseed stand oil, tung oil stand oil, gum turpentine, lightfast earth and mineral pigments, manganese/calcium drier (semi-rich version additionally contains fillers). When using the product, observe the complete product information (technical data sheet and safety data sheet).

Note: Contains solvents – ensure adequate ventilation and lay oil-soaked rags out flat to dry (risk of spontaneous combustion). Observe the safety data sheet.

Frequently asked questions

What is the difference between semi-fat and full-fat?
-semi-fat- (Art. 442) has a silk-matt to silk-gloss finish with good filling properties and is used for primer and intermediate coats. -full-fat- (Art. 443) is the glossy top coat. For less gloss, apply two coats of -semi-fat-.

What is the coating build-up?
Three coats, “fat over lean”: priming oil, then -medium-fat-, then -full-fat-. Apply each coat thinly and allow it to dry through completely.

Can I paint over old oil paint?
Yes, old oil and alkyd resin coatings, following the test instructions “Testing Existing Coatings”. Not on acrylic-based or soft synthetic resin coatings.

How do I maintain stand oil paint outdoors?
Check regularly and refresh with KREIDEZEIT maintenance oil when the gloss fades – this postpones the renovation coat by years.